![]() ![]() In essence, it is a switch that can be set to turn an appliance or device on for a specific amount of time and then off again. Introduction: What Is a Woods Timer and How Does It Work?Ī Woods Timer is a type of timer that is often used to control outdoor lighting, irrigation systems, and other devices. Additionally, the instructions should provide safety tips for using the timer and explain how to properly maintain it. The instructions should include details on how to install the timer, program it, and troubleshoot it if it is not working properly. Woods timers are devices that can be used to automate lights, appliances, or other devices, and can be programmed to operate on different settings. Woods timer instructions is a set of instructions for setting up and using a Woods timer. Conclusion: The Advantages of Having a Woods Timer in Your Home.Tips for Getting the Most Out of Your Woods Timer. ![]() Step-by-Step Instructions for Setting Up Your Woods Timer.Introduction: What Is a Woods Timer and How Does It Work?.Connect the red of the 3-wire cable to the black going to the light and to other wire of the switch, which appears to be gray in the diagram. Connect the black of the 3-wire cable to the black of the switch. Connect the white of the 3-wire cable to the white going to the light. Connect the red of the 3-wire cable to the black wire that was connected to the black of the 3-wire cable.Īt the garage install the new switch as shown in the diagram. Connect the white of the 3-wire cable to the other whites in the box. Connect the incoming hot, which is the black that was connected to the common terminal, to the black of the 3-wire cable. If you are willing to eliminate the switch in the house you can properly install your new switch. Using the ground as a neutral is strictly prohibited. The only way to properly wire these switches and lights is with a 4-wire cable. So why would the unlearned person that did this wiring do such a thing, you ask.īecause there is another light which is closer to the switch box in the house that is also being controlled by these switches. The black is being used to return power back to the box in the house. Therefore, the white is not available to be used as a neutral. The red and white have been used as a travelers. The circuit is complete and the light burns. Power goes through the switch and comes out the common terminal which has the black going to the light attached. Power coming in on one of the traveler wires (black and red) of the 3-wire cable. Power goes thru the switch and comes out one of the traveler terminals which have the black and red wires of the 3-wire cable attached.Īt the garage switch the neutral (white of the 3-wire cable) is (should be) attached to neutral (white) going to the light. The neutral (white) of that cable is (should be) connected to the neutral (white) of the 3-wire cable going to the garage. The hot (black) of that cable is connected to the common of that switch. Power is coming into the switch box in the house. Looking at the switch in the garage, the ground is being used as a neutral. You have a set of 3-way switches that are grossly miswired.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |